Kit Name: ALPCPU1E02_071 Kits superseded by this kit: ALPCPU1E01_H1071 Kit Dependencies: The following remedial kit(s) must be installed BEFORE installation of this, or any dependent, kit: ALPBASE01_071 In order to receive the all the corrections listed in this kit, the following remedial kits should also be installed: ALPSYS13_071 Kit Description: Version(s) of OpenVMS to which this kit may be applied: OpenVMS Alpha V7.1, V7.1-1H1 Files patched or replaced: o [SYS$LDR]SYS$CPU_ROUTINES_1E05.EXE (new image) Problems addressed in ALPCPU1E02_071 kit o ******* WARNING ******* Setting the SYSGEN parameter VMSD4 to 1 would be done at the extreme risk of permanent system failure. OpenVMS engineering highly recommends that VMSD4 be left set to the default value of 0, i.e. enable automatic power-off. *********************** On all previous systems, a system fan failure automatically triggered the power supply to remove power from the system. On the new Alpha "DIGITAL Personal Workstation" (DPWS) platform, operating system software is notified of any fan failures. It must respond by removing power from the system. This new Page 2 operating system feature is required for system FRS. However, for some special applications, one may desire to disable automatic system power-off, which can be achieved by setting the SYSGEN parameter VMSD4 to 1. The result will be continued operation after fan failure, but at the risk mentioned in the warning above. Problems addressed in ALPCPU1E01_H1071 kit o System(620) and Processor(630) correctable machine checks are not being logged to the error log file. Kit Installation Rating: The following kit installation rating, based upon current CLD information, is provided to serve as a guide as to which customers should apply this remedial kit. (Reference attached Disclaimer of Warranty and Limitation of Liability Statement) INSTALLATION RATING: 2 : To be installed by all customers using the following feature(s): The Alpha "DIGITAL Personal Workstation". Installation Instructions: Install this kit with the VMSINSTAL utility by logging into the SYSTEM account, and typing the following at the DCL prompt: @SYS$UPDATE:VMSINSTAL ALPCPU1E02_071 [location of the saveset] The saveset location may be a tape drive, or a disk directory that contains the kit saveset. The images in this kit will not take effect until the system is rebooted. If you have other nodes in your OpenVMS cluster, they must also be rebooted in order to make use of the new image(s). If it is not possible or convenient to reboot the entire cluster at this time, a rolling re-boot may be performed. Copyright (c) Digital Equipment Corporation, 1998 All Rights Reserved. Unpublished rights reserved under the copyright laws of the United States. Page 3 The software contained on this media is proprietary to and embodies the confidential technology of Digital Equipment Corporation. Possession, use, or dissemination of the software and media is authorized only pursuant to a valid written license from Digital Equipment Corporation. DISCLAIMER OF WARRANTY AND LIMITATION OF LIABILITY THIS PATCH IS PROVIDED AS IS, WITHOUT WARRANTY OF ANY KIND. ALL EXPRESS OR IMPLIED CONDITIONS, REPRESENTATIONS AND WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, OR NON-INFRINGEMENT, ARE HEREBY EXCLUDED TO THE EXTENT PERMITTED BY APPLICABLE LAW. IN NO EVENT WILL DIGITAL BE LIABLE FOR ANY LOST REVENUE OR PROFIT, OR FOR SPECIAL, INDIRECT, CONSEQUENTIAL, INCIDENTAL OR PUNITIVE DAMAGES, HOWEVER CAUSED AND REGARDLESS OF THE THEORY OF LIABILITY, WITH RESPECT TO ANY PATCH MADE AVAILABLE HERE OR TO THE USE OF SUCH PATCH.